升降舞台载荷传感器安装注意哪些问题？

在升降舞台http://www.sdsjpt.net/中，载荷传感器最重要的一点是传感器轴承座必须与卷筒轴保持同心度，以保证传感器的安装精度，安装时不能猛击、捶打传感器部位。
In the landing stage, the most important point load cell sensor bearing must remain concentric with the spool shaft, in order to ensure accuracy of the sensor installation, the installation can not hit, beat sensor site.

升降舞台所有紧固螺钉必须拧紧，露天使用应加防雨罩，控制显示仪表安装，可悬挂在离司机尽量近的位置，以便于司机观察和操作，安装要稳固、最好采用一定的防振措施。
Landing stage all fastening screws must be tightened Covers outdoor use should be added to control display instrument installation, it can be hung from the driver in a position as close as possible in order to observe and operate the driver, installed to secure the best use of certain anti-vibration measures.

从升降舞台http://www.sdsjpt.net/传感器至显示控制仪表的信号电缆，可以用4芯屏蔽电缆，也可以用普通的橡胶护套控制软电缆，但不管使用哪种电缆，芯线截面不得小于1.5mm，中间不得有接头，但可以使用接线盒内采用有防松措施的接线端子。
From the landing stage sensor to the display control of the signal cable, you can use 4-conductor shielded cable, you can use an ordinary rubber sheathed flexible control cable, but no matter what kind of cable, wire cross section of not less than 1.5mm, the middle may not have joints , but you can use the terminal box use have against rotation terminals.