1、检查登车桥http://www.sdsjpt.net/所有的液压管道和接头。管道不能有破损,接头不能有松动,必须将所有接头拧紧。
Ramps Check all hydraulic pipes and fittings. Pipes can not have broken, can not have loose joints, all joints must be tightened.
2、卸下并拆开登车桥下降阀,用压缩空气将柱塞吹净,然后装入,重新安上。
Remove and disassemble Ramps lowering valve, with compressed air blowing the plunger, then loaded reattach.
3、把登车桥液压油放尽弃掉,拧紧接头取出油过滤器,洗清后,用压缩空气清理干净,然后放回油箱,并连接好管路。
The hydraulic oil Ramps exhausted discarded, tighten the fitting Remove the oil filter, after cleared with compressed air to clean up, and then back into the tank and connected piping.
4、登车桥http://www.sdsjpt.net/全程升起,在这位置时,液压油面应高出箱底40~50毫米。
Ramps full rise, in this position, the hydraulic oil level should be higher than the bottom 40 to 50 mm.
公司名称:济南液压升降机械销售中心
联系人:安经理
电话:152-5313-4653
邮箱:347299818@qq.com
网址:www.sdsjpt.net
地址:山东省济南市济北开发区
手机移动端
微信扫一扫