登车桥如何操作？

登车桥给我们的生活带来了极大的便利，登车桥主要由搭板、面板、底架、安全挡板、支撑脚、升板油缸、搭板油缸、电控箱、液压站等组成。那么大家应该如何正确操作登车桥呢？
1、登车桥http://www.sdsjpt.net/在操作时首先要压动升柄，使登车桥上升，至高于车厢底板，然后车辆到位，松开回油阀，登车桥下降并使唇板平稳地搭接到车辆尾部,用链子把登车桥和车固定牢。
Ramps at the operating pressure of the first to move up the handle, make Ramps rise above the cabin floor, and then the vehicle in place, release the oil return valve, Ramps and lip steadily declined by hooking the rear of the vehicle, Ramps and with a chain to the car fixed firmly.
　
2、登车桥操作时合上电控箱内电源总开关，按下操作按钮，固定式登车桥面板慢慢上升，升到最大高度时，登车桥前端搭板开始伸出，当搭板升到与面板同一平面时，松开按钮，面板与搭板在同一平面内慢慢下降，搭板会自然地搭在汽车尾部车厢底面上。
Ramps close when operating a power control box power switch, press the action button, fixed Ramps panel slowly rose, rose to a maximum height, Ramps slab stretched out the front, when slab liter to the same plane with the panel, release the button, the panel and slab slowly declining in the same plane, slab naturally carriage ride in the rear of the car on the bottom surface.
 
3、登车桥http://www.sdsjpt.net/如果车厢底面低于安装登车桥的月台高度，在松开按钮使面板下降的同时，拉紧小链条使支撑脚偏离支撑脚垫缺口，面板和搭板就可以下降到低于月台高度处，直至搭板落到较低的车厢内底面上。
If the car underside Ramps Ramps installed below the height of the platform, release the button in the panel declined, while the supporting foot chain taut little deviation notch support pads,panels and slab can drop below at the height of the platform until the slab fell on the bottom surface of the lower compartment.
  
4、登车桥工作完毕后，按下操作按钮，面板与搭板一起上升，车开走，松开按钮，面板自动下落归位，最后切断电源总开关。
Ramps After work is completed, press the action button, the panel raised with the slab, the car drove off, release the button, the panel automatically return the whereabouts of the last off the power switch.